User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-36 6880497G01-B June 1999
DC-DC Converter
Perform the following procedures to remove and install the DC-DC Converter.
DC-DC Converter Removal
Perform the following steps to remove the DC-DC Converter.
1. Remove the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Removal").
2. Unplug the DC-DC Converter from the RF-B! transmitter controller chassis (see
Figure 6-6).
Figure 6-6: RF-B! Transmitter Controller (Front Panel Removed)
3. Gently pull the DC-DC Converter straight out and set aside.
DC-DC Converter Installation
Perform the following steps to install the DC-DC Converter.
1. Gently place the DC-DC Converter into the DC-DC Converter slot in the
RF-B! transmitter controller chassis, firmly seating the board card-edge connectors into
the backplane.
2. Install the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Installation").
705SRH-09
DC-DC Converter
RF-Baton! Control ModuleReference Module