User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-34 6880497G01-B June 1999
Transmitter Controller Installation
Perform the following steps to install the RF-B! transmitter controller.
1. Slide the new RF-B! transmitter controller chassis into the front of the transmitter cabinet.
2. Secure the RF-B! transmitter controller chassis to the cabinet using the four TORX screws
removed in paragraph, "Transmitter Controller Removal", Step 5.
3. From the back of the cabinet, connect the cables disconnected in paragraph, "Transmitter
Controller Removal", Step 4.
4. From the front of the cabinet, set the RF-B! transmitter controller POWER switch to
ON (|) (see Figure 6-4).
5. Switch on any other equipment connected to the RF-B! transmitter controller.
6. If necessary, install the front cabinet door (see paragraph, "Doors Installation".)