User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-33
RF-B! Transmitter Controller
Perform the following procedures to remove and install the RF-B! transmitter controller in the
RF-O! paging station.
Tools
#30 TORX driver
Transmitter Controller Removal
Perform the following steps to remove the RF-B! transmitter controller.
Note: Perform Step 1 if the door does not open at least 90 degrees.
1. Remove the front door (see paragraph, "Doors Removal".)
2. Set the RF-B! transmitter controller POWER switch to OFF (O) (see Figure 6-4).
Figure 6-4: RF-B! Transmitter Controller Front Panel
3. Power down any other equipment connected to the RF-B! transmitter controller.
4. From the back of the cabinet, label and disconnect the cables attached to the RF-B!
transmitter controller.
5. From the front of the cabinet, remove and retain the four #30 TORX screws securing the
RF-B! transmitter controller chassis to the cabinet (see Figure 6-4).
6. Slide the RF-B! transmitter controller chassis gently forward, and remove carefully.
RESET
Control On
Control Fail
Disable
Alarm
Distribution OK
GPS Lock
RFB Req
TX OK
RF-Baton!™
Serial Port
705SRH-10
POWER
POWER Switch
TORX Screws