User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-27
3. Reset the RF-B! transmitter controller.
At the prompt, type:
a 117 <Enter>
Note: You must reset the RF-B! transmitter controller after the test is complete to restore the normal
operating mode. The GPS receiver must perform a complete reinitialization before the RF-B!
transmitter controller enables paging.
<E_GPS_NOT_TRACKING_SATELLITES>
If the GPS receiver temporarily loses satellite tracking, the RF-B! transmitter controller
operates in a FREERUN mode. During a loss of satellite tracking, the error log is updated with
the error message <E_GPS_NOT_TRACKING_SATELLITES> and is indicated by a Simulcast
Manager state 5.
1. Start the SASM trace.
At the prompt, type:
a 192 SASM 4 <Enter>
Verify the Simulcast state.
2. Turn off the SASM trace.
At the prompt, type:
a 193 SASM 4 <Enter>
In the FREERUN mode the timing accuracy for the station depends on the accuracy of the
reference oscillator. The reference oscillator can maintain simulcast accuracy for 96 minutes.
After 96 minutes, the station is disabled from paging until satellite tracking resumes. While
paging is disabled, the error log is updated with the error messages <S_PAGING_DISABLED>
and <E_SASM_FREERUN_TIMEOUT>
. To get more information about the GPS receiver status
and why GPS tracking was lost, perform the following steps:
State:0-3: pps_occured: 1, pps_within_window: 1: SIMULCAST INITIALIZATION
State: 4, pps_occured: 1, pps_within_window: 1 : PAGING WITH GPS
State: 5, pps_occured: 1, pps_within_window: 1 : FREERUN