User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-26 6880497G01-B June 1999
<E_GPS_SELF_TEST_FAILED>
This procedure is only valid for the Motorola OncoreVP GPS receiver. Trimble does not
support self-test features.
1. Perform a self test on the GPS receiver.
At the prompt, type:
a 218 <Enter>
Below is an example of a FIPS: a 218 command that passed:
2. Read the station error log.
At the prompt, type:
a 104 <Enter>
If the error <E_GPS_SELF_TEST_FAILED> is in the error log, replace the GPS receiver.
(see paragraph, "Reference Module")
RESULTS:
CHANNEL 1 CORRELATION TEST: PASSED
CHANNEL 2 CORRELATION TEST: PASSED
CHANNEL 3 CORRELATION TEST: PASSED
CHANNEL 4 CORRELATION TEST: PASSED
CHANNEL 5 CORRELATION TEST: PASSED
CHANNEL 6 CORRELATION TEST: PASSED
1 KHz PRESENCE: PASSED
ROM LSByte CHECKSUM: PASSED
ROM MSByte CHECKSUM: PASSED
RAM LSByte: PASSED
RAM MSByte: PASSED
EEPROM: PASSED
DCXO SPI COMM: PASSED
RTC COMM & TIME: PASSED