User Manual

Table Of Contents
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-25
S_GPS_IS_DISABLED
If the <S_GPS_IS_DISABLED> error is in the error log, perform the following procedure:
1. Verify that GPS synchronization has not been user disabled.
At the prompt, type:
r 930 <Enter>
If the 930 parameter is set to 0, GPS synchronization is enabled. If the 930 parameter is set
to 1, GPS synchronization has been disabled.
2. If disabled, enable GPS synchronization.
At the prompt, type:
w 930 0 <Enter>
This causes the GPS receiver to reinitialize as if a power-on reset has occurred.
If the RF-B! transmitter controller GPS Lock front panel indicator does not light within
30 minutes, the GPS receiver is unable to receive signals from enough satellites.
3. Enable the GPS initialization trace.
At the prompt, type:
a 192 GPSC 8 <Enter>
4. Check the error log for the <E_GPS_NOT_TRACKING_SATELLITES>.
If <E_GPS_NOT_TRACKING_SATELLITES> is present, go to paragraph,
"<E_GPS_NOT_TRACKING_SATELLITES>".
This type of problem may be caused by RF cabling, GPS antenna defects, interfering
signals, or an obstruction to the GPS antenna.