User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-17
5. Verify that paging has not been disabled through FIPS, the 99 parameter is equal to zero.
At the prompt, type:
r99<Enter>
The system responds:
RFB FIPS: RR 99 0
6. If the 99 parameter is set to 1 (paging is disabled) enter the following command.
At the prompt, type:
w990<Enter>
7. Verify that paging is enabled.
At the prompt, type:
a 192 PCRM 2 <Enter>
The trace displays the paging status of the RF-B! transmitter controller. For example:
Paging is Enabled!
8. Verify that the Simulcast Manager has is in a paging enabled state.
At the prompt, type:
a 192 SASM 4 <Enter>
The trace displays the simulcast state and the 1 PPS status. For example:
RFB FIPS: State: 4, pps_occured: 1, pps_within_window: 1
State 4 and state 5 are paging enabled states for the simulcast manager. If the returned
state is not 4 or 5, the problem is in the Global Positioning System (GPS). Refer to
paragraph, "GPS Diagnostics".
9. Stop the trace.
At the prompt, type:
a 193 SASM 4 <Enter>
The trace stops.