User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-12 6880497G01-B June 1999
Verify RF-B! Transmitter Controller Receipt of Message Data
This section determines if the Outbound Paging Protocol Manager (OPPM) is receiving and
processing input messages.
1. Connect your FIPS terminal to the FIPS Serial Port on the front panel of the RF-B!
transmitter controller and log into the FIPS session (see Chapter 5, "Operation",
paragraph, "Service Terminal").
2. Verify the RF-B! transmitter controller is receiving data from the network.
At the prompt, type:
a 192 OPPM 4 <Enter>
The terminal displays the OPPM trace.
If there is no data scrolling across the screen (trace output) disable the network packet
trace and go to Step 5.
3. Verify that the rfChannelIndex, and subchannel are correct. These values are set in the
RF-C! controller configuration.
The following is a typical example of a Sync and SCI pattern: