User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-5
Bad DRAM or Flash SIMM
The RF-B! transmitter controller will not complete a reset if the Dynamic Random Access
Memory (DRAM) OR Flash Single In-line Memory Module (SIMM) or the software
programmed into it are defective.
1. Set the RF-B! transmitter controller power switch to OFF (O).
2. Remove the front panel (see paragraph, "Faceplate Removal").
CAUTION
Always observe antistatic precautions when handling memory modules or printed
circuit boards or other Wireless Messaging System (WMS) components.