User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Operation
June 1999 6880497G01-B 5-23
GPS Positional Data
These action commands request and display the positional data held by the GPS receiver. As
is done in Figure 4, paragraph, "OncoreVP GPS Value Recording", it is valuable to have the
GPS receiver positional data recorded in order to speed GPS acquisition if the RF-B! needs to
be replaced.
1. Use the following command to get the current receiver latitude.
At the prompt, type:
a 200 <Enter>
The system responds
Latitude: +118232934 msec,
32 degrees, 50 minutes, 32 seconds
2. Use the following command to get the current receiver longitude.
At the prompt, type:
a 201 <Enter>
The system responds
Longitude -350255243 msec,
-97 degrees, 17 minutes, 35 seconds
3. Use the following command to get the current receiver height.
At the prompt, type:
a 202 <Enter>
The system responds
RFB FIPS: RA 202 Height +0021568 cm (ellipsoid) +0024020 cm (msl)