User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Operation
June 1999 6880497G01-B 5-19
Starting an FM Test Mode
1. Start the test.
At the prompt, type:
a 176 [mod pat_1 pat_2 pat_3 pat_4 repetition_rate blocks bit_rate fsk] <Enter>
where:
– mod = 0 for frequency modulation (FM)
– pat_1, pat_2, pat_3, and pat_4 are the FM subchannel patterns chosen from Table 5-7
– repetition_rate ranges from 0–128 frames
– the number of data blocks per frame ranges from 0–11
– data bit_rate is chosen from Table 5-8
– fsk is chosen from Table 5-9:
The test transmission starts immediately. The FM test mode keys the transmitter.
Table 5-7: FM Subchannel Patterns
Pattern Index Pattern
0 Disabled
1 A Pattern
2 B Pattern
3 C Pattern
4 D Pattern
5 Big comma
6 Little comma
7 Staircase
8 Random