User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Operation RF-Baton! Transmitter Controller Installation and Operation
5-18 6880497G01-B June 1999
Starting an AM Test Mode
1. Start the AM test.
At the prompt, type:
a 176 [mod pat_1 pat_2 pat_3 pat_4 repetition rate] <Enter>
where:
– mod = 1 for amplitude modulation (AM)
– pat_1, pat_2, pat_3, and pat_4 are the AM subchannel pattern indexes chosen from
Table 5-6
– repetition rate = 0–128 frames
The test transmission starts immediately. The AM test mode keys the transmitter.
For more details on supported test transmission options, see the description of FIPS
action command 176 in Appendix C.
Note: Ensure that the distribution network is reconnected when the test is complete, so normal
processing can resume.
2. When the test is complete, disable the test mode.
At the prompt, type:
a 177 <Enter>
The test transmission ends immediately, and normal processing resumes.
Table 5-6: AM Subchannel Pattern Indexes
Pattern Index Pattern
0 Disabled
2 Random AM
4 Random AM with 1 sideband of training
5 Random AM with 2 sidebands of training