User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Operation
June 1999 6880497G01-B 5-9
Current MIB Version
For network management purposes, the Management Information Base (MIB) of the active
software version can be determined by reading FIPS parameter 154. For example, type:
r 154 <Enter>
The system responds:
RFB FIPS: RR 154 4 (Where the MIB version is 4.)
Network Configuration
The necessary initial network configuration of the RF-B! transmitter controller is detailed in
Chapter 4, "Installation", paragraph, "Networking Setup". The site-specific parameters set
during the installation procedure are necessary for proper message operation.
This section contains an overview and description of the FIPS availability of the network
configuration parameters of the RF-B! transmitter controller.
Table 5-4: Network Configuration Parameters
Parameter
FIPS
Parameter
ID
Description
UDP Port 55 The transport layer port number used for Outbound Paging Protocol (OPP)
message data.
SNMP IP 500-504 The Internet Protocol (IP) addresses for up to five independent network
managers.
Color Code 704 InFLEXion protocol transmitter color code located in outbound control
information. Each transmitter color code is unique.
Local IP 705 The IP address for the RF-B! transmitter controller. This is unique for each RF-
B! transmitter controller on the network.
Subnet Mask 706 The subnet mask of the physical subnetwork that the RF-B! transmitter
controller is connected to.
Gateway IP 708 The IP address of the router that connects to the RF-B! transmitter controller.