User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Operation RF-Baton! Transmitter Controller Installation and Operation
5-8 6880497G01-B June 1999
Configuration
This section contains RF-B! transmitter controller FIPS commands that allow you to check the
software and network configurations.
Software Configuration
The following commands provide access to the RF-B! transmitter controller software
configuration. The FLASH Single In-line Memory Module (SIMM) located on the BCM
contains two separate memory banks where RF-B! transmitter controller software can reside.
Only one bank, however, can be active at a time.
Active Software Bank
To determine which of the software banks is currently active, type:
r 901 <Enter>
The systems responds:
RFB FIPS: RR 901 <bank>
If bank = 1, Bank A is active. If bank = 2, Bank B is active.
The software version in the active bank can be determined by reading FIPS parameter 148. For
example; if the RF-B! transmitter controller is running software version 1.5.4, and you type:
r 148 <Enter>
The system responds:
RFB FIPS: RR 148 1.5.4
Dormant Software Bank
Likewise, the software version resident in the dormant bank can be determined by reading
FIPS parameter 152. For example; if the dormant software bank contains software version
1.4.4, and you type:
r 152 <Enter>
The system responds:
RFB FIPS: RR 152 1.4.4