User Manual

Debug Traces RF-Orchestra!™ Transmitter Installation and Operation
H-2 6880493G02-C July 2000
Disabling Debug Traces
To turn off traces that are enabled, type the following:
RFO FIPS: A 193 <TASK> <FLAG>
<TASK> is the same debug trace identifier as described in the Table H-1.
<FLAG> is a decimal number defining the individual debug traces to be disabled for the
specified Trace. That is, each debug trace is uniquely identified by a single bit (1,2,4,8,16,...)
being set within a particular TRACE. To disable one or more traces, specify the trace(s) with
the <FLAG>. For example:
Table H-1: RF-O! Transmitter Debug Trace TASK Identifiers
TASK Software Task Description
COHQ Collector DSP task. Responsible for communications between the host processor and the
Collector DSP.
DIAG Diagnostics task.
DIDQ Distributor DSP Communications Task. Responsible for sending/receiving messages to/from
the Distributor DSP.
ITCM Internal Transmitter Controller Manager Task. Responsible for executing most FIPS action
commands.
M1HQ Modulator 1 DSP Task. Responsible for communications between the host processor
(MC68360) and the Modulator 1 DSP.
M2HQ Modulator 2 DSP Task. Responsible for communications between the host processor
(MC68360) and the Modulator 2 DSP.
MPCM Maintenance Path Control Manager Task. Controls the communications between the RF-O!
transmitter and the plug and play interface (RF-B! or other transmitter controller).
RFCQ Radio Frequency Channel Control Task. Responsible for assuring that the DSPs and Exciter
are programmed to the correct frequency prior to keyup.
SHMI Station Hardware Manager Task. Responsible for monitoring station hardware peripherals
such as Pendulum, UHSO, and Ambient Temperature Sensor.
SPCQ Station Power Control Manager Task. Responsible for controlling the transmitter power output
based on number of subchannels, modulation type, power cutbacks, and power leveling.
SPIQ Serial Peripheral Interface Task. Responsible for communications with devices on the SPI
bus.