User Manual

RF-Orchestra!™ Transmitter Installation and Operation Alarms and Error Messages
July 2000 6880493G02-C F-25
I_FFDS_FRAME_FLUSHED
(Removed after RF-O! transmitter version 1.2.0)
This signals the user that a transmission frame has
been flushed by a DSP. It is normal for this message to
be logged at startup, and occasionally during normal
operation. This message is normally accompanied by
one of the following Plug-N-Play error messages:
E_START_TIME_ERROR,
E_INCOMPLETE_FRAME_ERROR,
E_MODULATION_TYPE_ERROR,
E_FREQ_OFFSET_ERROR,
E_INVALID_COMMAND_TYPE_ERROR,
E_UNEXPECTED_SYMBOL_COMMAND_ERROR,
E_SYMBOL_DATA_COMMAND_FORMAT_ERROR,
E_END_OF_COMMAND_ERROR,
E_WORK_AHEAD_WINDOW_ERROR,
E_CHECK_COMMAND_FORMAT_ERROR,
Informational
It is normal for occasional occurrences of
this Informational Message. If excessive
(more than 10 per day) Plug-N-Play
errors are received, there may be a
network loading/delay issue between the
RFC and the RF-B! transmitter controller,
or a Plug-N-Play issue between the
RF-O! transmitter and RF-B! transmitter
controller.
If excessive occurrences of this message
are experienced, contact Motorola.
I_FREQ_CHANGE_DELAY_CHANGED
The Frequency Change Delay parameter (2057) was
changed during normal operation after bootup. The
RFO will disable paging and reaquire the 1PPS signal.
Informational
No action required.
Note: Paging will resume after 1PPS
signal is reaquired (usually around ten
seconds).
I_PAGING_ACCESS_DISABLED
The transmitter was disabled by a User (RFO FIPS: w
99 1).
Informational
If the transmitter is still disabled (see RFO
FIPS: a 83 - Station Status), and this is
not the desired state, enable the
transmitter by writing parameter 99 to 0.
(RFO FIPS: w 99 0).
Table F-3: RF-O! Transmitter Error/Alarm Code Definitions (Sheet 23 of 27)
Error and Description
Alarm
Severity
Action