User Manual

RF-Orchestra!™ Transmitter Installation and Operation Alarms and Error Messages
July 2000 6880493G02-C F-13
E_MOD1_INPUT_OVERFLOW_ERROR
Both Modulator DSPs did not receive the same amount
of data for each logical subchannel. Interruption of the
input stream to the modulator is caused by other Plug-
and-Play Errors. In a multiple channel operation any
Plug and Play error has the potential to cause a Mod1
or Mod2 Input Overflow error.
Major
If the error persists (more than 10 occur-
rences per day), save error log and con-
tact Motorola.
NOTE: This is a Plug-and-Play Error.
Transmitter was Disabled for 2 seconds,
and DSP buffers were flushed.
E_MOD2_INPUT_OVERFLOW_ERROR
Both Modulator DSP’s did not receive the same amount
of data for each logical subchannel. Interruption of the
input stream to the modulator is caused by other Plug-
and-Play Errors. In a multiple channel operation any
Plug and Play error has the potential to cause a Mod1
or Mod2 Input Overflow error.
Major
If the error persists (more than 10 occur-
rences per day), save error log and con-
tact Motorola.
NOTE: This is a Plug-and-Play Error.
Transmitter was Disabled for 2 seconds,
and DSP buffers were flushed.
E_MODULATION_TYPE_ERROR
An invalid/unsupported Modulation Type was received
in the Plug-and-Play Control Command.
Major
If the error persists, save error log and
contact Motorola.
NOTE: This is a Plug-and-Play Error.
Transmitter was Disabled for 2 seconds,
and DSP buffers were flushed.
E_MP_BAD_CHECKSUM
Received packet did not match calculated checksum.
Data is invalid and packet is discarded.
Minor
If the error persists, save the error log and
contact Motorola.
E_MP_BAD_FORMAT
Base error used for all invalid messages received on
the Maintenance Path.
Minor
If the error persists, save the error log and
contact Motorola.
E_MP_EVENT_OVERFLOW
There were too many Events that occurred within the
last 3 seconds for the PnP Maintenance Path to
transmit all of them to the Controller.
Minor
If the error persists, save the error log and
contact Motorola.
E_MP_INVALID_COMMAND
The command received from the BCM is not
recognized.Possible maintenance path incompatibility
between RF-O! transmitter and RF-B!.
Minor
If the error persists, save the error log and
contact Motorola.
Table F-3: RF-O! Transmitter Error/Alarm Code Definitions (Sheet 11 of 27)
Error and Description
Alarm
Severity
Action