User Manual

RF-Orchestra!™ Transmitter Installation and Operation
July 1999 6880493G02-C xxxv
Tables
Table 1-1: Keyboard Conventions Used in This Manual, 1-3
Table 2-1: RF-O! Transmitter Controls, 2-13
Table 2-2: RF-O! Transmitter Front Panel Indicators, 2-14
Table 2-3: OCM Backplane Connectors, 2-18
Table 2-4: Environmental Specifications, 2-30
Table 2-5: General Specifications, 2-31
Table 2-6: InFLEXion Electrical Requirements, 2-35
Table 2-7: InFLEXion Electrical Requirements, 2-36
Table 2-8: ReFLEX and FLEX Electrical Requirements, 2-36
Table 3-1: Cabinet and Rack Dimensions, 3-2
Table 3-2: Equipment Cabinet Weight and Floor Loading - Cabinet X128, 3-4
Table 3-3: Example of Antenna Identification Tape Marking, 3-12
Table 4-1: Recommended Tools for Installation, 4-4
Table 4-2: Recommended Test Equipment for Installation, 4-5
Table 4-3: Recommended Parts for Installation, 4-6
Table 5-1: Service Terminal Interface Parameters, 5-2
Table 5-2: Commands Table, 5-3
Table 5-3: Subchannel Offset From Center Frequency, 5-9
Table 5-4: Offset Values Corresponding kHz, 5-9
Table 5-5: Station Error Log Entries, 5-12
Table 5-6: Site-Specific Orchestra Control Module User Account Data, 5-14
Table 5-7: Normal RF-O! Transmitter LED Conditions Without Network Data, 5-16
Table 5-8: RF-O! Transmitter Power Setting Chart, 5-28
Table 6-1: RF-Orchestra! Front Panel Indications Troubleshooting Chart, 6-3
Table 6-2: Paging Disabled Definitions, 6-5
Table 6-3: Description of RFCQ Trace Fields, 6-14
Table 6-4: RFCQ Trace Conversion Table, 6-15
Table 6-5: Variables for Checking Power Amplifier, 6-17
Table 6-6: Variables for Checking Power Supplies, 6-20
Table 6-7: DIP Switch Settings, 6-50
Table 6-8: Minimum Parameter List, 6-90
Table 6-9: Additional Parameter List, 6-91
Table A-1: Acronyms and Definitions List, A-1
Table B-1: RF-O! Transmitter Backplane Connectors, B-2
Table B-2: Plug-and-Play -- Connector J4, B-3
Table B-3: Power Amplifier Signaling Connectors—J5 through J6, B-4
Table B-4: Connectors—J9 through J12, B-4