User Manual

RF-Orchestra!™ Transmitter Installation and Operation FIPS Read/Write Commands (ver. 2.0.0)
July 2000 6880493G02-C E-23
Modulation AM Pilot
Power
r 2055
w 2055 <arg>
Return/Set the Pilot Power Level used in AM
modulation. Used by the Modulator DSP’s.
Note: If Power Control is ENABLED, changes to this
parameter will NOT take effect until Power Control is
DISABLED.
WARNING: This parameter intended for Lab/
Development use only!
32767 0 1600
Modulation AM
Sideband Power
r 2056
w 2056 <arg>
Return/Set the Sideband Power Level used in AM
modulation. Used by the Modulator DSP’s.
Note: If Power Control is ENABLED, changes to this
parameter will NOT take effect until Power Control is
DISABLED.
WARNING: This parameter intended for Lab/
Development use only!
32767 12426 0
Frequency Change
Delay
r 2057
w 2057 <arg>
The time required to change to another channel
center frequency.
Note: If this parameter is changed during normal
operation, the RFO will disable and reaquire the
1PPS signal, causing interruption of paging traffic.
WARNING: This parameter intended for Lab/
Development use only!
2147483
647
us
(0x7fffffff)
0
us
0
us
Minimum Workahead
Time
r 2058
w 2058 <arg>
The minimum time between when a command
(control or data) is fully received by the transmitter
and its start time.
WARNING: This parameter intended for Lab/
Development use only!
100000
us
0
us
50000
us
Workahead Window
Width
r 2059
w 2059 <arg>
The time between the earliest and latest time that
the controller may finish sending a command to the
transmitter, in microseconds.
WARNING: This parameter intended for Lab/
Development use only!
500000
us
50000
us
50000
us
Table E-1: RF-O! Transmitter Parameters—Read/Write Commands (Sheet 23 of 27)
Name and Command
Description
Ranges
Default
Upper Lower