User Manual

FIPS Read/Write Commands (ver. 2.0.0) RF-Orchestra!™ Transmitter Installation and Operation
E-4 6880493G02-C July 2000
Xilinx Type
r 710
Return/Set the model of the FPLD on the RFO.
WARNING: This parameter intended for Lab/
Development use only!
414
Active Flash Bank
r 901
w 901
This command returns/sets the application bank
which currently used (read). Writing to this
parameter will take effect on the next station reset.
211
One Pulse Per Second
Window Size
r 902
Return the 1 PPS Simulcast Window Size.
Arg Window Size(nanosec)
1 480
2 950
3 1900
4 3810
5 7620
WARNING: This parameter intended for Lab/
Development use only!
515
IF Frequency
r 951
Return the IF Frequency used in programming the
Exciter Synthesizers.
WARNING: This parameter intended for Lab/
Development use only!
22500 70000 107400
Exciter Attenuator
(Txlin Register 00)
r 952
w 952 <arg>
Return/Set the value of Exciter IC Attenuator level.
Used for enabling/disabling DC Offset Training.
WARNING: This parameter should only be modified
if DC Offset Training (parameter 998) is enabled.
Note: If Power Control is ENABLED, changes to this
parameter will NOT take effect until Power Control is
DISABLED.
255 0 22
Table E-1: RF-O! Transmitter Parameters—Read/Write Commands (Sheet 4 of 27)
Name and Command
Description
Ranges
Default
Upper Lower