User Manual

RF-Orchestra!™ Transmitter Installation and Operation / Appendix E
July 2000 6880493G02-C E-1
FIPS Read/Write Commands
(ver. 2.0.0) E
This appendix summarizes the Friendly Integrated Paging System (FIPS) read and write
commands for the RF-Orchestra! transmitter. These commands are used to display or modify
the values of the parameters stored in the RF-O! transmitter parameter database.
Table E-1: RF-O! Transmitter Parameters—Read/Write Commands (Sheet 1 of 27)
Name and Command
Description
Ranges
Default
Upper Lower
Paging Access
Disabled
r 99
w 99 <arg>
Paging Access Disable is used to locally disable the
transmitter. If the transmitter is not already disabled,
writing this parameter to ‘1’ will cause the transmitter
to cease transmission. The DISABLE LED will light,
the PWR CTBK LED will start blinking, and the
TX_OK output to the RFB will change to the “Not
OK” state. To re-enable paging access, and there
are no other disables active, write this parameter to
‘0’.(See also, a 83, or parameter 100)
100
Paging Disabled Status
r 100
Gives the current disabled status of the station. If the
transmitter is disabled by the software, the value
read will be a number other than 0.
0xFFFFF
FFF
00
FIPS Inactivity Timer
r 136
w 136 <arg>
Return/Set the Inactivity Timer which will cause the
host to exit FIPS if no keystrokes are recorded
during the elapsed time in this parameter.
3600 s 60 s 300 s
FIPS Baud Rate
r 140
w 140 <arg>
This command returns/sets the communications
data rate of the FIPS port. The following arguments
apply:
1 = 1200 bps 5 = 19200 bps
2 = 2400 bps 6 = 38400 bps
3 = 4800 bps 7 = 57600 bps
4 = 9600 bps 8 = 115200 bps
814