User Manual

RF-Orchestra!™ Transmitter Installation and Operation Maintenance
July 2000 6880493G02-C 6-3
Check Front Panel Indications
Table 6-1 provides information about front panel indications, possible failures, and corrective
actions. (LEDs are listed as they appear on the front panel from left to right.)
Table 6-1: RF-Orchestra! Front Panel Indications Troubleshooting Chart
LED Color Status Condition
CONTROL ON Green
On
Control module is ON and has successfully gone through boot
process
Off
Control module is OFF or has not successfully gone through
boot process
CONTROL FAIL Red
On Control module has not successfully gone through boot process
Off Control module has successfully gone through boot process
DISABLE Red
On
The transmitter is disabled. Paging has ceased. Check station
status (A83) and Alarm log (A99) to determine cause of disable.
Off Normal operation
ALARM Red
On
Station alarm has been detected. There is an active alarm in the
A 99 log. Clear this log with A 103.
Off Normal operation
PA KEYED Green
On Station Keyed
Off Station Dekeyed
EXCITER LOCKED Green
On Station locked on transmit frequency
Off One or both exciter synthesizers or Tranlin LO not locked
FULL POWER Green
On Station operating without any cutbacks
Off
Station is operating with a cutback or is shutdown. Check station
status (A 83).
POWER
CUTBACK
Yellow
On
Any PA not at full power (Cutback). Check station status (A83)to
determine the reason for the cutback.
Blinking
Transmitter is Disabled (Shutdown). Check station status (A 83)
and alarm log (A 99).
Off All PAs capable of transmitting at full power