User Manual

Operation RF-Orchestra!™ Transmitter Installation and Operation
5-14 6880493G02-C July 2000
General Operational Setup and First Time Use
The factory installs all software necessary for operating the RF-O! transmitter. Certain
site-specific setups are necessary before the RF-O! transmitter is ready for paging operation.
The following sections provide detailed procedures for all site-specific setups.
All setup procedures use a service terminal to access the FIPS protocol.
Recording Data for the RF-O! Paging Station
Use the service terminal to access the frequency parameters listed for your particular location
and record the information on Table 5-6.
.
Note: After recording this information, keep this data in a safe place for future reference.
Table 5-6: Site-Specific Orchestra Control Module User Account Data
Command Record Value
r 2000 Frequency Table Entry 1
r 2001 Frequency Table Entry 2
r 2002 Frequency Table Entry 3
r 2003 Frequency Table Entry 4
r 2004 Frequency Table Entry 5
r 2005 Frequency Table Entry 6
r 2006 Frequency Table Entry 7
r 2007 Frequency Table Entry 8
r 2008 Frequency Table Entry 9
r 2009 Frequency Table Entry 10
r 2010 Frequency Table Entry 11
r 2011 Frequency Table Entry 12
r 2012 Frequency Table Entry 13
r 2013 Frequency Table Entry 14
r 2014 Frequency Table Entry 15
r 2015 Frequency Table Entry 16