User Manual

RF-Orchestra!™ Transmitter Installation and Operation Operation
July 2000 6880493G02-C 5-5
Read Parameter Command
A read command returns a parameter value as stored in internal RF-O! transmitter memory.
The read command appears in the following format:
r [parameter #] <Enter>
For example, to read the Active Bank Software type the following command:
RFO FIPS: r 148 <Enter>
RFO FIPS: RA 148 2.0.0 (value depends on software version)
Appendix E lists the RF-O! transmitter read commands.
Write Parameter Command
A write command writes a single parameter value to the internal RF-O! transmitter memory.
The write command appears in the following format:
w [parameter #] [parameter] <Enter>
For example, issue a write command to set the center frequency to 940 MHz for the 1st entry
in the PNP Channel Table as follows:
RFB FIPS: w 2000 940000.0
RFB FIPS: RW 940000.0
Appendix E lists the RF-O! transmitter write commands.
Note: In a few cases, a write command behaves like an action command in the sense that the write
command causes the RF-O! transmitter to change operating modes.
Note: Some parameters are write-protected. Attempting to write to write-protected parameters will
not modify the value of the parameter.