Specifications

3005 ‘Illegal command. Send CAL:VAL:RES.’ The only command
accepted after a CAL:CONF:RES is a CAL:VAL:RES
command.
3006 ‘Illegal command. Send CAL:VAL:VOLT.’ The only
command accepted after a CAL:CONF:VOLT is a
CAL:VAL:VOLT command.
3007 ‘Invalid signal conditioning module.’ The command sent to an
SCP was illegal for its type.
3008 ‘Too few channels in scan list.’ A Scan List must contain at
least two channels.
3012 ‘Trigger too fast.’ Scan list not completed before another
trigger event occurs.
3015 ‘Channel modifier not permitted here.’
3019 ‘TRIG:TIM interval too small for SAMP:TIM interval and
scan list size.’ TRIG:TIM interval must allow for completion of
entire scan list at currently set SAMP:TIM interval. See
TRIG:TIM in Chapter 5, the Command Reference.
3020 ‘Input overvoltage.’ Calibration relays opened (if JM2202 not
cut) to protect module inputs and Questionable Data Status bit
11 set. Execute *RST to close relays and/or reset status bit.
3021 ‘FIFO overflow.’ Indicates that the FIFO buffer has filled and
that one or more readings have been lost. Usually caused by
algorithm values stored in FIFO faster than FIFO was read.
3026 ‘Calibration failed.’
3027 ‘Unable to map A24 VXI memory.’
3028 ‘Incorrect range value.’ Range value sent is not supported by
instrument.
3030 ‘Command not yet implemented!!’
3032 ‘0x1: DSP-Unrecognized command code.’
3033 ‘0x2: DSP-Parameter out of range.’
3034 ‘0x4: DSP-Flash rom erase failure.’
3035 ‘0x8: DSP-Programming voltage not present.’
3036 ‘0x10: DSP-Invalid SCP gain value.’ Check that SCP is seated
or replace SCP. Channel numbers are in FIFO.
3037 ‘0x20: DSP-Invalid *CAL? constant or checksum. *CAL?
required.’
3038 ‘0x40: DSP-Couldn’t cal some channels.’ Check that SCP is
seated or replace SCP. Channel numbers are in FIFO.
3039 ‘0x80: DSP-Re-Zero of ADC failed.’
Error Messages
360 Appendix B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com