Specifications

Appendix B
Error Messages
Possible Error Messages:
-108 ‘Parameter not allowed.’
-109 ‘Missing parameter’
-160 ‘Block data error.’
-211 ‘Trigger ignored.’
-212 ‘Arm ignored.’
-213 ‘Init ignored.’
-221 ‘Settings conflict.’
-222 ‘Data out of range.’
-224 ‘Illegal parameter value.’
-240 ‘Hardware error.’ Execute *TST?
-253 ‘Corrupt media.’
-281 ‘Cannot create program.’
-282 ‘Illegal program name.’
-310 ‘System error.’
-410 ‘Query INTERRUPTED.’
1000 ‘Out of memory.’
2001 ‘Invalid channel number.’
2003 ‘Invalid word address.’
2007 ‘Bus error.’
2008 ‘Scan list not initialized.’
2009 ‘Too many channels in channel list.’
2016 ‘Byte count is not a multiple of two.’
3000 ‘Illegal while initiated.’ Operation must be performed before
INIT or INIT:CONT ON.
3004 ‘Illegal command. CAL:CONF not sent.’ Incorrect sequence
of calibration commands. Send CAL:CONF:VOLT command
before CAL:VAL:VOLT and send CAL:CONF:RES command
before CAL:VAL:RES.
Appendix B 359
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com