Specifications

Comments
·
<transition_mask> may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
·
If both the STAT:OPER:PTR and STAT:OPER:NTR registers have a
corresponding bit set to one, any transition, positive or negative, will set the
corresponding bit in the Event register.
·
If neither the STAT:OPER:PTR or STAT:OPER:NTR registers have a
corresponding bit set to one, transitions from the Condition register will have no
effect on the Event register.
·
Related Commands: STAT:OPER:PTR?, STAT:OPER:NTR
·
Set to all ones by: STAT:PRESet and power-on.
·
*RST Condition: No change
Usage STAT:OPER:PTR 16 When “Measuring” bit goes true, set bit 4 in
Status Operation Event register.
STATus:OPERation:PTRansition?
STATus:OPERation:PTRansition? returns the value of bits set in the Positive
Transition Filter (PTF) register.
Comments
·
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
·
Related Commands: STAT:OPER:PTR
·
*RST Condition: No change
Usage STAT:OPER:PTR? Enter statement returns current value of bits
set in the PTF register
STATus:PRESet
STATus:PRESet sets the Operation Status Enable and Questionable Data Enable
registers to 0. After executing this command, none of the events in the Operation
Event or Questionable Event registers will be reported as a summary bit in either the
Status Byte Group or Standard Event Status Group. STATus:PRESet does not clear
either of the Event registers.
Comments
·
Related Commands: *STB?, SPOLL, STAT:OPER:ENABLE,
STAT:OPER:ENABLE?, STAT:QUES:ENABLE, STAT:QUES:ENABLE?
·
*RST Condition: No change
Usage STAT:PRESET Clear both of the Enable registers
VT1419A Command Reference
STATus
Chapter 6 297
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com