Specifications

·
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is
uint16.
·
Related Commands: *CAL?, CAL:ZERO, INITiate[:IMMediate],
STAT:OPER:EVENT?, STAT:OPER:ENABLE, STAT:OPER:ENABLE?
·
*RST Condition: No Change
Usage STATUS:OPERATION:CONDITION? Enter statement will return value from condition
register
STATus:OPERation:ENABle
STATus:OPERation:ENABle <enable_mask> sets bits in the Enable register that
will enable corresponding bits from the Event register to set the Operation summary
bit.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
enable_mask numeric (uint16) 0-32767 none
Comments
·
<enable_mask> may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
·
VXI Interrupts: When Operation Status Group bits 4, 8, 9, 10, or 11 are enabled,
VXI card interrupts will occur as follows:
When the event corresponding to bit 4 occurs and then is cleared
, the card
will generate a VXI interrupt. When the event corresponding to bit 8, 9, 10,
or 11 occurs, the card will generate a VXI interrupt.
NOTE: In C-SCPI, the C-SCPI overlap mode must be on for VXIbus
interrupts to occur.
·
Related Commands: *STB?, SPOLL, STAT:OPER:COND?,
STAT:OPER:EVENT?, STAT:OPER:ENABLE?
·
Cleared By: STAT:PRESet and power-on.
·
*RST Condition: No change
Usage STAT:OPER:ENABLE 1 Set bit 0 in the Operation Enable register
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns the value of bits set in the Operation
Enable register.
VT1419A Command Reference
STATus
294 Chapter 6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com