Specifications

Comments
·
Only one VXIbus TTLTRG line can be enabled simultaneously.
·
When Accepted: Not while INITiated
·
Related Commands: ABORT, INIT…, TRIG…
·
*RST Condition: OUTPut:TTLTrg<0 through 7> OFF
Usage OUTP:TTLT2 ON Enable TTLTRG2 line to source a trigger
OUTPUT:TTLTRG7:STATE ON Enable TTLTRG7 line to source a trigger
OUTPut:TTLTrg<n>[:STATe]?
OUTPut:TTLTrg<n>[:STATe]? returns the current state for TTLTRG line <n>.
Comments
·
Returned Value: Returns 1 or 0. The C-SCPI type is int16.
·
Related Commands: OUTP:TTLT<n>
Usage OUTP:TTLT2? See if TTLTRG2 line is enabled (returns 1 or
0)
OUTPUT:TTLTRG7:STATE? See if TTLTRG7 line is enabled
OUTPut:TYPE
OUTPut:TYPE <select>,(@<ch_list>) sets the output drive characteristic for
digital SCP channels.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
Units
select discrete (string) PASSive | ACTive seconds
ch_list string 132 - 163 none
Comments
·
If the channels specified are on an SCP that doesn’t support this function an error
will be generated. See the SCP’s User’s Manual to determine its capabilities.
·
PASSive configures the digital channel/bit to be passive (resistor) pull-up to
allows more than one output to wire-or'd together.
·
ACTive configures the digital channel/bit to both source and sink current.
·
Related Commands: SOURce:PULSe:POLarity, OUTPut:TYPE?
·
*RST Condition: OUTP:TYPE ACTIVE (for TTL compatibility)
Usage OUTP:TYPE PASS,(@156:159) make channels 56 to 59 passive pull-up
VT1419A Command Reference
OUTPut
Chapter 6 251
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com