Specifications

OUTPut
The OUTPut subsystem is involved in programming source SCPs as well as
controlling the state of VXIbus TTLTRG lines 0 through 7.
Subsystem Syntax OUTPut
:CURRent
:AMPLitude <amplitude>,(@<ch_list>)
:AMPLitude? (@<channel>)
[:STATe] 1|0|ON|OFF,(@<ch_list>)
[:STATe]? (@<channel>)
:POLarity NORMal | INVerted,(@<ch_list>)
:POLarity? (@<channel>)
:SHUNt 1|0|ON|OFF,(@<ch_list>)
:SHUNt? (@<channel>)
:TTLTrg
:SOURce TRIGger | FTRigger | SCPlugon | LIMit
:SOURce?
:TTLTrg<n>
[:STATe] 1|0|ON|OFF
[:STATe]?
:TYPE PASSive | ACTive,(@<ch_list>)
:TYPE? (@<channel>)
:VOLTage
:AMPLitude <amplitude>,(@<ch_list>)
:AMPLitude? (@<channel>)
OUTPut:CURRent:AMPLitude
OUTPut:CURRent:AMPLitude <amplitude>,(@<ch_list>) sets the VT1505A
Current Source SCP channels specified by <ch_list> to either 488 µAor30µA.
This current is typically used for four-wire resistance and resistance temperature
measurements.
NOTE This command does not set current amplitude on SCPs like the VT1532A Current
Output SCP.
Chapter 6 245
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com