Specifications

MEMory
The MEMory subsystem allows using VME memory as an additional reading
storage buffer.
Subsystem Syntax MEMory
:VME
:ADDRess <A24_address>
:ADDRess?
:SIZE <mem_size>
:SIZE?
:STATe 1|0|ON|OFF
:STATe?
NOTE This subsystem is only available in systems using an Agilent/HP E1405B/06A
command module.
Use Sequence *RST
MEM:VME:ADDR #H300000
MEM:VME:SIZE #H100000 1 MB or 262,144 readings
MEM:VME:STAT ON
*
* (set up VT1419A for scanning)
*
TRIG:SOUR IMM let unit trigger on INIT
INIT
*OPC? program execution remains here until VME
memory is full or the VT1419A has stopped
taking readings
FORM REAL,64 affects only the return of data
FETCH? return data from VME memory
NOTE When using the MEM subsystem, the module must be triggered before executing
the INIT command (as shown above) unless an external trigger (EXT trigger) is
being used. When using EXT trigger, the trigger can occur at any time.
Chapter 6 241
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com