Specifications

DIAGnostic
The DIAGnostic subsystem allows special operations to be performed that are not
standard in the SCPI language. This includes checking the current revision of the
Control Processor’s firmware and that it has been properly loaded into flash
memory.
Subsystem Syntax DIAGnostic
:CALibration
:SETup
:MODE 0 | 1
:MODE?
:TARe
[:OTD]
:MODE 0 | 1
:MODE?
:CHECksum?
:CUSTom
:LINear <table_range>,<table_block>,(@<ch_list>)
:PIECewise <table_range>,<table_block>,(@<ch_list>)
:REFerence
:TEMPerature
:IEEE 1 | 0
:IEEE?
:INTerrupt
[:LINe] <intr_line>
[:LINe]?
:OTDetect
[:STATe] 1|0|ON|OFF,(@<ch_list>)
[:STATe]? (@<channel>)
:QUERy
:SCPREAD? <reg_addr>
:VERSion?
218 Chapter 6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com