User`s manual

www.vxitech.com
EX7000-OEM Basic Operation 23
Digital Interface Controller Connectors
The J1 and J1A connectors are used to connect the relay driver board to the controller board. J1
and J1A are interchangeable for ease of usage. When J20 is jumpered, J1A will be utilized,
otherwise, J1 is used.
Relay Drive Connectors
Connectors J2 through J13 are Relay Drive connectors. On each connector, there will be:
1) 6 relay drive outputs capable of 200 mA (410 mA for three or fewer channels)
2) 6 relay indicator inputs which will provide the relay coil status, if applicable
3) 4 relay ID inputs
4) 1 relay reset output, capable of sinking up to 800 mA to reset all relay coils
Relay Drive Connectors
Designator Pin Signal Pin Signal
1
PWR_BANKx
2
RELAY_DRIVE0
3
RELAY_DRIVE1
4
RELAY_DRIVE2
5
RELAY_DRIVE3
6
RELAY_DRIVE4
7
RELAY_DRIVE5
8
RELAY_INDICATOR0
9
RELAY_INDICATOR1
10
RELAY_INDICATOR2
11
RELAY_INDICATOR3
12
RELAY_INDICATOR4
13
RELAY_INDICATOR5
14
RELAY_ID0
15
RELAY_ID1
16
RELAY_ID2
17
RELAY_ID3
18
RELAY_RST_DRV
J2
through
J13
19
GND
20
+5V
Connector
Pin
Locations
2
1
20
19
Mating
Connector
3M P/N: 3421-7600 (or similar)
CAUTION
It is imperative that TTL banks only have TTL devices connected to them. Connecting an
open-collector device to a TTL port will result in damage to the RDB and, potentially, to
other equipment in the test system. Failure to comply with this warning will result in voiding
the manufacturer’s warranty.
Power Connectors
Either J14 or J14A can be used to supply dc power to the relay driver board. PWR_BANKx
voltage can range from 5 V to 45 V.
Power Connectors
Designator Pin Signal Pin Signal
1
PWR_BANK0
2
GND
3
PWR_BANK1
4
GND
5
PWR_BANK2
6
GND
J14 & J14A
7
+5 V
8
+5 V
Connector
Pin
Locations
18
Mating
Connector
AMP P/N: 640250-8 (connector)
AMP P/N: 640706-1 (crimp pins)