Datasheet

3
VUTEC CORPORATION
www.vutec.com
TEL: [phone]
FAX: [phone]
E-MAIL: [e-mail]
Please read this through before trying to program a receiver – the receiver will exit program mode if you stop to read
this page during programming! Also, make sure you have a programming transmitter – it will have a white spot on the
PC board visible when the battery door is open.
Programming the Receiver
The following settings are factory defaults:
− Channel Channel 1
− Action Mode Maintained
− Manual Input Switch Mode SPDT
− Motor Direction Mode Standard
− ALL button Mode Enabled
− Run Time 3 minutes
To Enter Program Mode
Press the STOP, OPEN_7 and CLOSE_7 buttons all simultaneously, then release all three buttons, within 6
seconds.
Press OPEN_#, where # is the channel of the receiver to be programmed. Initially, this would be OPEN_1.
The Red LED on the receiver must now be lit, if it is not, repeat the above steps. Be sure the OPEN_# is correctly
entered.
To Exit Program Mode
Press the STOP button; the Red LED will go off.
If you do not give the receiver any commands for 20 seconds while in program mode; it will exit by itself.
For all of the following actions, the Red LED must be on:
Programming Table
The following table uses # for the receiver’s main channel number – new units will have a 1 where the # is.
S = STOP button O = OPEN button C = CLOSE button
Desired Change LED: On Blink Blink
Reset EVERYTHING to factory default S+O7+C7 O ALL Hold 5sec. until blink
Main Channel to 2 from Channel 1 S+O7+C7 O1 C1 O2
Main Channel to “N” S+O7+C7 O# C1 O “N”
1
st
Group Channel to “N” S+O7+C7 O# C2 O “N”
1
st
Group Channel OFF S+O7+C7 O# C2 O ALL
2
nd
Group Channel to “N” S+O7+C7 O# C3 O “N”
2
nd
Group Channel OFF S+O7+C7 O# C3 O ALL
Reset the following actions to factory default S+O7+C7 O# C6 O ALL
Momentary Motor Action S+O7+C7 O# C6 O 1
Reverse Motor Direction S+O7+C7 O# C6 O 2
Disable ALL buttons from Transmitter S+O7+C7 O# C6 O 3
Reset the following action to factory default S+O7+C7 O# C7 O ALL
SPST manual switch S+O7+C7 O# C7 O 1
Set the Run Time to 100x+10y+z seconds
Min. = 0 0 1 (1 sec). Max. = 2 9 9 (299 sec). Use O10 for 0
S+O7+C7 O# C8 Ox Oy Oz