Operating instructions

Page 13
Bell TV HDTV 82/91 Alternate (satellites 82, 91)
STATIONARY USE ONLY
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then WAIT 4 MORE SECONDS.
2. Press and release the ON button 36 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use. To configure your receiver,
GO TO PAGE 14 AND RUN THE CHECK SWITCH.