Operating instructions

Bell TV HDTV 82/91 (satellites 82, 91)
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then W
AIT 4 MORE SECONDS.
2. Press and release the ON button 32 times.
The status light starts rapidly flashing green and red.
3. Press and hold the ON button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use. To configure your receiver,
GO TO PAGE 14 AND RUN THE CHECK SWITCH.
Bell TV Standard Digital (satellite 91)
1. On the VuQube controller, press and release the
ON button. Wait for the status light to flash orange,
and then W
AIT 4 MORE SECONDS.
2. Press and release the ON button 8 times.
The status light starts rapidly flashing green and red.
3. Press and hold the button for 4 seconds.
The status light will turn orange for 1 second,
and then start flashing green or red.
4. Press OFF.
5. After you have successfully configured the antenna, you must configure your
receiver for mobile use. To configure your receiver,
GO TO PAGE 14 AND RUN THE CHECK SWITCH.
Page 12
STEP 2: ANTENNA CONFIGURATION FOR BELL TV