Owner`s manual

Page 7
STEP A: CHECK SWITCH TEST (Before satellite acquisition)
1. Disconnect the coax from “SAT IN” on the back of your receiver.
2. Turn on your TV and receiver.
3. On your receiver’s remote, press (MENU, 6, 1, 1) to
display the signal meter screen.
4. Highlight “Check Switch” and press SELECT.
Note: Some receivers may prompt you to select
“Check Switch” a second time to initiate the test.
5. Make sure “Superdish” and “Alternate” boxes
are NOT selected.
Note: Not all receivers will display a screen
with options that include “Superdish” and
“Alternate” boxes.
6. Highlight “Test” and press SELECT.
Your receiver will perform a check switch test. (This process will take several minutes.)
7. When test is complete, a screen similar to this should appear.
(Receivers are always changing, and therefore screen
graphics may vary.)
If you get a WARNING screen stating you have
fewer satellites than previously detected, with
the option to save the settings, select “SAVE”
and continue. (You may have to choose “SAVE” twice.)
8. Highlight “OK” and press SELECT to return to the Point Dish Screen.
9. Reconnect the coax to “SAT IN” on the back of your receiver.
10. GO TO PAGE 8, STEP B.
Screen graphics may vary.
“NO SWITCH DETECTED”
or
“INSTALLED DEVICE UNKNOWN”
or similar