Owner`s manual

Page 5
6. When signal strength appears, stop rotating the antenna.
Use the UP, DOWN, LEFT and RIGHT arrows as necessary
to maximize the satellite signal.
For DISH and Bell TV, verify the signal meter screen
shows the correct satellite.
7. Press POWER again to turn the VuQube remote OFF. (The remote turns off automatically
after 90 seconds if no buttons are pressed.)
8. Exit the Signal Meter Screen to download the guide and view your programming.
STORE / RECALL (Manual Satellite Switching)
You can STORE up to 4 satellite positions using the STORE/RECALL feature.
1. Lock onto a satellite using steps 1-6 on pages 4-5.
2. Press and hold the 1 button for 3 or more
seconds. The number “1” will illuminate
and the display will show P1.
(When button is released, display will
show the elevation.)
3. Repeat for up to 3 more satellites using the 2, 3 and 4 buttons.
4. To RECALL a stored position, momentarily press the desired
button (1, 2, 3 or 4) (do not press for more than 2 seconds).
The recalled location and “Switching” will be displayed as the
antenna moves to the recalled position.
NOTE: It may take several minutes to download programming from the satellite before you can watch TV.
If you move the VuQube you must re-acquire the satellite. Follow the directions on pages 4-5.
NOTE: When recalling a stored position, if you hold the button for more than 2 seconds, the current position will be
stored rather than a previous position being recalled.
To cancel moving to a stored position, press any of the arrow buttons.
If you move the VuQube you will have to re-acquire the satellites and store the positions again. Follow the
instructions on pages 4-5.