User manual

NOTE: Once the battery is fully charged while the scanner is off, battery indicator

will briefly

display on LCD screen and will turn off automatically.

4.2. Inserting a microSD/microSDHC Memory Card (not included)

To operate the scanner, you must insert a microSD/microSDHC card (not supplied) to record and

store your pictures.

To insert the microSD/microSDHC memory card:

1. Turn OFF the scanner

2. Insert the microSD/microSDHC card into the microSD card slot (with metal side facing

upwards). Gently press in until the card is latched and clicked into place.

4.3. Power ON/OFF the Scanner

Power on/off the scanner by pressing and holding for 3 seconds.

NOTE:

1. If the scanner is turned on for the first time, it will enter Date & Time/Language setup mode.

Once Date & Time/Language setting is completed, scanner will enter into standby mode.

2. If Auto off is set at "3 Min" (refer to section 5), the scanner will turn off automatically if

scanner action is not detected within 3 minutes.

4.4. Setting Date & Time/Language

1. Press to jump to next setting option: YEAR MONTH DATE HOUR  MINUTE.

When setting up the value for MINUTE, press

to return to the previous setting option

until it reaches the YEAR option.

2. Press

or to set the number corresponding to each setting.

3. Press

to confirm and move to next setting.

4. After completing the setting for MINUTE, it will enter language setup screen.

5. Press

or to select the desired language.

6. Press

to confirm and enter standby status.

4.5. Calibrating the Scanner (OPTIONAL. ONLY WHEN NEEDED)

NOTE: If scanned images are too dark or too bright, you may need to adjust the white balance by

calibrating the scanner.

1. Take the scanner out from the docking station.

2. Wipe off any dirt on the surface of the scanning lens with the clean dry cloth provided.

3. Place the scanner on the white portion of the calibration paper provided. Press and hold the