User manual


7
To set Date & Time/Language:
1. Press to jump to next setting option: YEAR ÆMONTH ÆDATE ÆHOUR Æ MINUTE.
When setting up the value for MINUTE, press to switch to the previous setting option until it
reaches the YEAR option.
2. Press or to set the figure corresponding to each setting.
3. Press to confirm and move to next setting.
4. After completing the setting for MINUTE, it will enter Language setup screen.
5. Press or to select English, Spanish or French.
6. Press to confirm and enter into standby status.
4.4 How to Scan
Note: To scan, make sure your scanner is not connected to the computer.
1. Turn on your scanner by pressing and holding for 3 seconds.
2. Place the document on a flat surface and hold down the document with one hand.
3. Place the scanner on the edge of the paper approximately 5/8 to 3/4 of an inch onto the edge of the paper
to ensure the whole document can be scanned. Make sure to keep the scanning area within the scanning
width indicators marked on the side of the scanner.
 
4. Hold the scanner flat against the material and then press once to start the scanning process.