User manual

12
4.8 How to Calibrate the Scanner
Note: If the scanned images are too dark or too bright, you may need to calibrate your scanner by adjusting the
white balance. Follow the below steps to perform calibration:
1. Wipe off any dirt on the surface of the scanning lens with the clean dry cloth provided.
2. Press turn on the scanner. Place the scanner on the white area of the White Balance Calibration
paper provided.
3. Press and hold button. While holding the button, press the button and then release
both buttons to enter into auto-calibration mode. The message “1. Calibration starts. Do not move the
device!” will appear on LCD screen.
4. Do not move the scanner until “2. Scan the calibration sheet!” appears on the LCD screen. Start scanning
the white area of the calibration paper by sliding the scanner across the paper (slide the scanner
backwards if necessary).
5. “3. Calibration completed!” message will appear on the LCD screen when calibration is completed.
6. Press any button to power off the scanner.
5.Connecting to Computer
View your scanned files on your comptuer
You may also connect your scanner to your computer and view pictures on the computer monitor
1. Press and hold to turn on your scanner, connect your scanner to your
computer to enter into USB mode. “USB” icon will display on LCD screen.
2. Your computer will recognize the scanner as a “Removable Disk”. Click
“Open folder to view files” to view, import, copy, move or to delete scanned
files.