User Manual

07
VULTA TORNADO
A Note about Maximum Output
When the flashlight is in High mode, the
battery discharge, drive circuit, and LED will
all be producing heat, and the lamp head may
become extremely hot. Please be cautious
when touching it. To protect the battery,
circuit, and LED, and to extend the lifetime
of the flashlight, we do not recommend
continuously running the flashlight on High
mode for more than 10 minutes.
INSTALLING BATTERIES
The Tornado FL-E25P can be powered by
two CR123 or RCR123 (3 or 3.7 V) batteries
or a single 18650 (3.7 V) battery. When using
an 18650 battery, 2600 mAh capacity with
overcharge protection is recommended.
To install a battery, follow these steps:
1. Make sure the flashlight is turned off.
2. Unscrew and remove the tailcap from the
flashlight.
3. Insert the battery or batteries with the
positive terminal(s) facing the lamp head.
4. Screw the tailcap back onto the flashlight
until secure.