User Manual

07
VULTA TORNADO
A Note about Maximum Output
When the flashlight is in High mode, the
battery discharge, drive circuit, and LED will
all be producing heat, and the lamp head may
become extremely hot. Please be cautious
when touching it. To protect the battery,
circuit, and LED, and to extend the lifetime
of the flashlight, we do not recommend
continuously running the flashlight on High
mode for more than 10 minutes.
INSTALLING BATTERIES
The Tornado FL-D45P can be powered by two
18650 (3.7 V) or four CR123 or RCR123 (3 or
3.7 V) batteries. When using 18650 batteries,
2600 mAh capacity with overcharge protection
is recommended.
Note: Make sure to load the batteries with
the positive and negative terminals facing
the proper directions. The FL-D45P has
a reverse-polarity protection circuit that
prevents damage due to improper battery
installation, but the flashlight will not turn on
if the batteries are oriented incorrectly.
To install a battery, follow these steps:
1. Make sure the flashlight is turned off.