USER MANUAL HURRICANE 216 LUMEN GENERAL PURPOSE LED FLASHLIGHT FG-B15
Thank you for choosing Vulta. The Vulta FG-B15 Hurricane projects a crisp, white light with a 216-lumen maximum output. Designed as a reliable, general-purpose flashlight, the FG-B15’s three constant-on modes provide a range of illumination options depending on your needs—whether it’s sending a bright beam of light down the street or a low glow for reading a map on the side of the highway. In addition to constant-on, there are strobe and SOS modes for emergency situations and signal communication.
market-leader, which combines high efficiency with high drive-current. The LED is housed in an ultraclear, tempered glass lens that optimizes resistance to impacts and scratches and maximizes throw distance. Crafted from MIL-SPEC Type III hard anodized aluminum alloy with a stainlesssteel bezel, and with a waterproof rating of IPX-8, the FG-B15 Hurricane is a rugged tool that will withstand harsh environments.
PRECAUTIONS ⚠⚡ • Please read and follow these instructions and keep this manual in a safe place. • This flashlight is extremely bright and can cause temporary or even permanent blindness. Do not shine the flashlight in the eyes of any person or animal. When powering on the flashlight, make sure to point it down or away from you and anyone else. • The surface of this product can become hot after prolonged use. Be careful when touching it, and make sure to keep it away from anything flammable or combustible.
• Install the battery in the proper orientation as indicated by the instructions in this manual. • This product is waterproofed for freshwater only. If it comes into contact with salt water, immediately dry the flashlight and remove the battery, reassemble, and rinse with freshwater. Dry thoroughly and install a new battery. • Do not attempt to disassemble or repair this product. It is dangerous and will also void the warranty. • Keep this product away from children.
PRODUCT DIAGRAM A A LED B LAMP HEAD C HEAT SINK AREA D SIDE BUTTON E LOW-VOLTAGE WARNING LED (RED) B F O-RING G TAILCAP H 1/4˝-20 THREADED SOCKET C D E F G Also Included: H HOLSTER USER MANUAL LANYARD WITH STAINLESS STEEL RING TWO-YEAR LIMITED WARRANTY SPARE O-RING 06 VULTA HURRICANE
A Note about Maximum Output When the flashlight is in High mode, the battery discharge, drive circuit, and LED will all be producing heat, and the lamp head may become extremely hot. Please be cautious when touching it. To protect the battery, circuit, and LED, and to extend the lifetime of the flashlight, we do not recommend continuously running the flashlight on High mode for more than 10 minutes. INSTALLING BATTERIES The FG-B15 is powered by a single CR123/ RCR123 (3 or 3.7 V) battery.
OPERATION The FG-B15 employs a side-button system to power on the flashlight and switch between the different modes. TURNING ON THE FG-B15 Constant On: To turn on the FG-B15, give the side button a quick press. Upon powering on, the flashlight will enter High mode. The next time you power on the flashlight, it will enter the most recent constant-on mode. Temporary On: Press and hold the side button for temporary-on functionality. The flashlight will remain on until you release the side button.
SETTING THE MODE High/Medium/Low: There are three constanton modes: High, Medium, and Low. When the flashlight is in Constant-On mode, press and hold the side button to cycle through the three constant-on modes in descending order of brightness. Strobe and SOS: Strobe mode continuously emits quick flashes of bright light. In SOS mode, the flashlight blinks brightly in the international Morse code distress signal pattern (· · · – – – · · ·).
THREADED SOCKET The 1/4˝-20 socket at the bottom of the flashlight is perfect for mounting the light to any photo accessory with 1/4"-20 male threads or attaching the included lanyard with stainless steel ring. O-RING MAINTENANCE The FG-B15’s O-ring is installed on the threaded portion to help seal out water. The O-ring is prelubricated to extend its life, ensure smooth operation, and increase water resistance.
SPECIFICATIONS OUTPUT High, Strobe, SOS: 216 lm Medium: 57 lm Low: 3 lm BEAM INTENSITY 2,652 cd LED TYPE CREE XM-L2 POWER SOURCE One CR123/RCR123 (3 or 3.7 V) battery RUNTIME High: 1.5 hr. Medium: 10 hr. Low: 50 hr. THREAD SIZE 1/4˝-20 CONSTRUCTION Body: MIL-SPEC Type III hard anodized aerospace-grade aluminum alloy Bezel: Stainless steel Lens: Tempered glass IMPACT RESISTANCE Up to 6.5´ (2 m) WATERPROOFING IPX-8 standard, up to 6.
TWO-YEAR LIMITED WARRANTY This VULTA product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of two (2) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.
