Specifications

– 18 –
GUIDELINES FOR MAINTAINING STAINLESS STEEL SURFACES
There are three things that can break down stainless steel and allow corrosion to develop: 1) Abrasion;
2) Deposits and water; and 3) Chlorides.
Avoid rubbing with steel pads, wire brushes, or scrapers that can leave iron deposits on stainless steel;
instead, use plastic scouring pads or soft cloths. For stubborn stains, use products such as Cameo,
Talc, or Zud First Impression. Always rub parallel to the polish lines or with the grain.
Hard water can leave deposits that promote rust on stainless steel. Treated water from softeners or
certain filters can eliminate these mineral deposits. Other deposits from food or lubrication must be
properly removed by cleaning. Use mild detergent and non-chloride cleaners. Rinse thoroughly. Wipe
dry. If using chloride containing cleaners or sanitizers, rinse repeatedly to avoid stainless steel
corrosion. Where appropriate, apply a polish recommended for stainless steel (such as Benefit or
Super Sheen) for extra protection and lustre.
MAINTENANCE
WARNING: THE STEAMER AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING,
OR SERVICING THE STEAMER.
WARNING: THE COOKING COMPARTMENTS CONTAIN LIVE STEAM. STAY CLEAR WHILE
OPENING EACH DOOR.
BOILER BLOWDOWN
At least once daily after the steamer boiler has been in operation, press [ 0 ] to blow down the boiler
in order to remove sediments, scalants, and lime build-up in the boiler.
BOILER PRESSURE RELIEF VALVE
At least once every day, check the pressure relief valve (set to open at 15 psi) to see that it is functioning
properly. The valve is located on the top left side of the boiler. Trip the pressure relief valve when the
steam gauge shows 4 psi or above. When steam escapes, release the valve.
DOOR GASKETS
If the door gasket is nicked or cut it must be replaced. Damage to the gasket sealing surface will cause
steam leakage.
If a leak occurs in one corner only and gasket appears serviceable, turn the stainless steel screw on
the gasket plate immediately adjacent to the leaking corner one-half turn counterclockwise. Do not
attempt excessive turning of screws since misalignment of door is likely.
AIR INTAKE TO THE BLOWER
The air intake to the blower needs to be periodically (once a month) cleaned or wiped.