Specifications

– 6 –
VG30, VG40, VE30 & VE40 BRAISING PANS
INSTALLATION CODES AND STANDARDS
The Vulcan braising pan must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). Copies may be obtained from
The American Gas Association Accredited Standards Committee Z223, @ 400 N. Capital St. NW,
Washington, DC 20001, or the Secretary Standards Council, NFPA, 1 Batterymarch Park
Quincy, MA 02169-7471.
3. NFPA Standard # 96 Vapor Removal from Cooking Equipment, latest edition, available from
the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
4. In the Commonwealth of Massachusetts all gas appliances vented through a ventilation hood
or exhaust system equipped with a damper or with a power means of exhaust shall comply with
248 CMR.
In Canada:
1. Local codes.
2. CAN/CSA-B149.1 Natural Gas Installation (latest edition).
3. CAN/CSA-B149.2 Propane Installation Code (latest edition), available from the Canadian Gas
Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
LEVELING AND ANCHORING THE TILTING BRAISING PAN
1. Place the braising pan in the final installed position.
2. Place a carpenter's level on the braising pan table top and turn the adjustable feet to level the
braising pan table top side-to-side and front-to-back. Do not attempt to level the braising pan
base.
3. Mark hole locations on the floor through the anchoring holes provided in the flanged
adjustable feet.
4. Remove the tilting braising pan from the installation location and drill holes in the locations marked
on the floor. Insert proper anchoring devices (not supplied).
5. Place the tilting braising pan back in the installation location.
6. Place a carpenter's level on top of the braising pan, and re-level side-to-side and front-to-back.
7. Bolt and anchor the tilting braising pan securely to the floor.
8. Seal bolts and flanged feet with Silicon sealant or equivalent compound.
SERVICE CONNECTIONS
To access service and utility connections, remove the left side panel. To remove, hold the panel from
underneath and lift it up. While holding the panel up, swing out the lower part of the panel until it clears
the bottom flange and remove the panel. If required, the rear panel can also be removed using the same
procedure.
The gas-powered braising pan is supplied with a 120-volt power cord.
The electrical connection for the electric braising pan can be accessed from the rear or the left panel.