Specifications

Under certain conditions, the oven will emit a short trill tone alarm when the operator presses a button. This indicates that
something is preventing the oven from operating properly. Check the display screen for the following messages:
MESSAGE ACTION
HIGH POWER IS NOT ON
--> Press ANY key <--
1. Press any button to clear the message.
2. Restart the cook cycle.
[16] DOOR IS OPEN
Door detected open after cook cycle started.
1.
Check for obstructions that may be keeping the
door from clo
sing properly.
2. Restart the cook cycle.
DOOR IS NOT CLOSED
Door detected open at start of cook cycle.
1. Check for obstructions that may be keeping the
door from closing properly.
2. Restart the cook cycle.
[18] OVEN OVERHEATED
ALLOW TO COOL
1.
Press any button to clear the message.
2. Make sure the blower is on.
3. Check vent/duct for obstructions.
4.
Close door, wait for the oven to cool.
5. Restart the cook cycle.
[15] LAMPS ARE ON *!
H.V. IS TURNED OFF
An irregular lamp condition was detected.
1. Turn the oven off.
2. Turn the oven on.
3. Restart the cook cycle.
OVEN TOO HOT NOW
ITEM MAY OVERCOOK
--> Press ANY KEY <--
Cannot do enough compensation.
1. Check that the recipe is valid.
2.
Allow the oven to cool, then try again.
3. Restart the cook cycle.
STEP 1 + STEP 2 TIME
EXCEEDS MAX (10:39)
--> Press ANY Key <--
Total cook time exceeds the maximum in a Two-
step recipe.
1. Press any button to clear the message.
2. Press the CLEAR button to remove the entry.
3. Adjust either the Step 1 time or the Step 2 time
so that the total does not exceed 10:39.
[19] UPPER LAMP
SHIELD OUT OF PLACE
1. Check that the upper lamp shield is properly
installed.
2. Restart the cook cycle.
If these actions do not reset the oven and allow the cooking cycle to begin, contact your local Vulcan Service Office.
FORM
31020 (4
-
97)
-
23
-
PRINTED IN U.S.A.