Specifications
To make the adjustment, press the 1 button. Pressing the 2 button will take you to the normal programming screen for the cook
time. Pressing the 1 button will take you to the following screen:
Recipe
1
1 = lighter . . . 5 = darker
Enter (1-
5) =3
Then Press NEXT
The factory setting for this adjustment is 3. If your product was getting darker with each successive cook, try changing the setting
to 2 or 1. If your product was getting lighter, try changing the setting to 4 or 5.
As a guideline, the following foods MAY cook more consistently using the following settings. The actual best setting will depend
on your specific food product.
Setting Food Type
1 Single 6" (152 mm) parbake pizza
2
Chicken Tenders
Sub Sandwiches
8" (203 mm) and 12" (305 mm) parbake pizza
3
12" (305 mm) and 16" (406.5 mm) raw dough pizza
Three 6" (152 mm) raw dough pizzas
French Fries
4 Steak
5
Chicken Breasts
Fish
Remember, this setting only affects the finished consistency of a product being cooked multiple times in a row using this recipe
number. It will not affect the basic recipe for a single cook cycle from a cool oven.
After entering the new setting, you can press NEXT to step through the rest of the program settings, or press the SAVE button to
store the changes and exit the program mode.
BLOWER
The oven blower turns off automatically after approximately 4 minutes of non use, adding to the oven's energy efficiency.
CLEANING
WARNING: DISCONNECT ELECTRICAL SUPPLY BEFORE CLEANING THE OVEN.
The interior cleanliness of the FlashBake oven is essential to ensure maximum efficiency of your oven. Keeping the oven clean
and free of food debris will minimize the possibility of smoke and odors from food stuck on the lamp shields and interior walls.
The interior of the oven cavity is lined with highly reflective materials that allow the oven to cook with exceptional speed. These
materials MAY NOT, under any circumstances, be cleaned with abrasive materials or chemicals that are not recommended for
aluminum. If the non-recommended type chemicals are used, they can etch and scratch the cavity, causing a loss in efficiency
and result in the need for repairs.
-18-