Service manual

ELECTRIC CONVEYOR OVENS - REMOVAL AND REPLACEMENT OF PARTS
Pa
g
e 7 of 24
4. Pull the entire conveyor assembly from the
oven.
NOTE: Conveyor will need to be lifted so crumb tray
slides will clear as assembly is pulled out.
5. To replace conveyor, reverse the procedure.
Conveyor Belt
1. Remove conveyor assembly as outlined in
”CONVEYOR ASSEMBLY/BELT”.
2. Loosen belt tension screws at the end of the
belt track.
3. Rotate belt manually until you locate the wide
end-hooks of the splicin
g
strands where the belt
should disconnected.
4. Remove splicin
g
strands by unhookin
g
ends
and squeezin
g
ends to
g
ether and withdrawin
g
thru link.
5. Assemble in reverse order. Adjust conveyor
belt tension as outlined in “CONVEYOR BELT
TENSION”.