Service manual

– 9 –
3. Disconnect the water hoses and remove the
control panel from the rinse station.
NOTE: When hose fittings are removed, inspect the
hose washers for cracking and wear. Replace with
new washers if needed.
4. Remove the two screws securing the water
fittings to the control panel and remove the
fittings.
5. Reverse the procedure to install new water
fittings.
8. Remove the thermostat bulb from the tank
mounting brackets.
9. Reverse the procedure to install new
thermostat.
Water Fittings
WARNING: SHUT OFF WATER BEFORE
SERVICING.
1. Remove the rinse station control panel as
outlined under Covers and Panels.
2. With an 1/8" Allen wrench, loosen the
setscrews and remove the knobs.